Make: - Laser Settings for Engraving Hot Dogs
Adam from X-Laser sent in this important last-minute Fourth of July tip for those of you who have laser cutters nearby at your BBQ:
We used an Epilog Helix 35W, I found that the sweet spot for hot dogs was 1200DPI, 14% speed and 100% power. We had less success rastering ground beef though, it seems to be better suited for vector engraving.
Now that's hot... :P
No comments:
Post a Comment
NOTE: Anonymous Commenting has been turned off for a while... The comment spammers are just killing me...
ALL comments are moderated. I will review every comment before it will appear on the blog.
Your comment WILL NOT APPEAR UNTIL I approve it. This may take some hours...
I reserve, and will use, the right to not approve ANY comment for ANY reason. I will not usually, but if it's off topic, spam (or even close to spam-like), inflammatory, mean, etc, etc, well... then...
Please see my comment policy for more information if you are interested.
Thanks,
Greg
PS. I am proactively moderating comments. Your comment WILL NOT APPEAR UNTIL I approve it. This may take some hours...